Canon Saddle Finisher-AF2, Руководство по обслуживанию

Страница: 173 / 244

Chapter 5
5-11
5.3.2.6 Adjusting Position of Feed Belt
0021-1711
Execute this adjustment when replacing the feed belt of the intermediate
process tray or EEPROM on the finisher controller PCB, or in the case of
variation in delivery stack.
Adjusting method is as follows:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front cover and put the door switch tool into the door switch [1].
F-5-42
4) Remove the screw [2] to remove the switch cover [1].
F-5-43
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
F-5-44
6) Press switch SW385 [1] to start position adjustment of the feed belt.
F-5-45
7) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the distance
between the belt [4] and the sheet interval [5] is reduced to increase
feeding force of the belt. In the same way, by pressing SW384 once, the
LED indicates "+1" and the distance between the belt [4] and the sheet
interval [5] increased to reduce feeding force of the belt. (Adjustment
range: +4 to -4).
[1]
[2]
[1]
MEMO:
1. Increase feeding force by setting adjustment value to negative value (-1
to -4) in the case of wear of the feed belt or using recycled paper (paper with
large surface resistance).
2. Reduce feeding force by setting adjustment value to positive value (+1 to
+4) in the case that dent on the paper edge is shown.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]