53
Adjusting Image
Proje
cti
ng
an
Im
age
Adjusting Keystone Distortion
The
D.SHIFT/KEYSTONE
button corrects the keystone distortion.
■
Auto adjustment
Press the
D.SHIFT/KEYSTONE
button, and then the
AUTO SET
button.
■
Manual adjustment
1
Press the D.SHIFT/KEYSTONE button to pop up a window shown at the lower right.
2
Press the pointer buttons to adjust the focus.
• Keystone can be adjusted within the range of ± 20 degrees. If the keystone distortion is
too large to adjust, move the projector installation position. (
• The amount of adjustment may be smaller depending on type of input signal.
• The result of keystone adjustment is memorized. If you place the projector at the same
position, the keystone adjustment is not necessary.
• Signals are processed digitally when keystone distortion is corrected. The image may
look different from the original one. In addition, the aspect ratio of the image may change.
• If you select [16:9 D. image shift] for [Screen aspect], the keystone adjustment will be dis-
abled. Project the image at right angle to the screen.
Remote control
Top control
[ ]: Reduces the length of the
upper edge.
<
Remote control
Top control
[ ]: Reduces the length of the
lower edge.
<