Canon PowrShot G5, Руководство по обслуживанию

Страница: 69 / 161

3-21
CHAPTER 3. REPAIR INSTRUCTION
Fig. 3-21 MODE DIAL
ZOOM LEVER
UNIT
Coat the sliding
surface with
Logenest Rambda
A-74.
Coat it with
the Dia bond
1663G.
(1)-5
MODE DIAL SPRING
(1)-3
MODE DIAL
BASE UNIT
Projected
part Receptacle
hole
TOP COVER UNIT
(1)-4
MODE DIAL BALL
MODE DIAL MODE DIAL BASE UNIT
(1)-1
(1)-1, (1)-3
MODE DIAL
CAP
MODE DIAL
MODE DIAL
CAP
(1)-3
MODE DIAL
(1)-2
XA4-9170-359
BLACK
M1.7
(SELF TAP)
3.5mm
q
q
Be careful not to
drop the MODE
DIAL BALL and
the MODE DIAL
SPRING
CAUTION
(1)-3
(1)-4, (1)-5
NOTE2 (Assembling)
NOTE3 (Assembling)
NOTE1 (Assembling)
2.3.1.3 MODE DIAL
(1) MODE DIAL
1. Peel off the MODE DIAL CAP from the MODE DIAL.
2. Remove the screw of
q
.
3. Remove the MODE DIAL BASE UNIT, then remove the MODE DIAL from the TOP COVER UNIT.
4. Remove the MODE DIAL BALL.
5. Remove the MODE DIAL SPRING.
CAUTION
Be careful not to drop the MODE DIAL BALL and the MODE DIAL SPRING.
NOTE1 (Assembling)
Attach the MODE DIAL and the MODE DIAL CAP with Dia bond, and coat the sliding surface of the
MODE DIAL with Logenest Rambda A-74.
NOTE2 (Assembling)
Align the large hole and small hole of the receptacle with the large projection and small projection of the
projected part, and install the MODE DIAL.
NOTE3 (Assembling)
Insert the MODE DIAL SPRING into the hole at the side of the ZOOM LEVER UNIT, and place the
MODE DIAL BALL on top of it as shown in the illustration.