84
Before Use
Basic Guide
Advanced Guide
1
Camera Basics
2
Auto Mode
3
Other Shooting Modes
5
Playback Mode
4
P Mode
6
Wi-Fi Functions
7
Setting Menu
8
Accessories
9
Appendix
Index
Saving Images to a Connected Computer
Connect to your access point via Wi-Fi as follows.
Also refer to the access point user manual.
Confirming Access Point Compatibility
Confirm that the Wi-Fi router or base station conforms to the Wi-Fi
Connection methods vary depending on whether the access point
supports Wi-Fi Protected Setup (WPS,
non-WPS access points, check the following information.
●
Network name (SSID/ESSID)
The SSID or ESSID for the access point you use. Also called the
“access point name” or “network name”.
●
Network authentication / data encryption (encryption method /
encryption mode)
The method for encrypting data during wireless transmission. Check
which security setting is used: WPA2-PSK (AES), WPA2-PSK
(TKIP), WPA-PSK (AES), WPA-PSK (TKIP), WEP (open system
authentication), or no security.
●
Password (encryption key / network key)
The key used when encrypting data during wireless transmission. Also
called the “encryption key” or “network key”.
●
Key index (transmit key)
The key set when WEP is used for network authentication / data
encryption. Use “1” as the setting.
●
If system administrator status is needed to adjust network
settings, contact the system administrator for details.
●
These settings are very important for network security. Exercise
adequate caution when changing these settings.
●
The following Windows settings are configured when you run the
utility in step 2.
-
Turn on media streaming.
This will enable the camera to see (find) the computer to access
via Wi-Fi.
-
Turn on network discovery.
This will enable the computer to see (find) the camera.
-
Turn on ICMP (Internet Control Message Protocol).
This allows you to check the network connection status.
-
Enable Universal Plug & Play (UPnP).
This will enable network devices to detect each other
automatically.
●
Some security software may prevent you from completing the
settings as described here. Check the settings of your security
software.
