Canon Paper Deck-V1, Руководство по обслуживанию

Страница: 57 / 90

Chapter 3
3-15
F-3-55
There are 2 claws on the upper sensor cover. Be
sure to take care not to break the claws when
detaching it.
3) Remove the screw [1], and detach the sensor plate
[2].
4) Remove the 5 screws [3], and detach the plate [4].
F-3-56
5) Insert a hex wrench [2] into the hole of the lifter
drive shaft [1] to keep it from turning.
If you fail to keep it in place, the lifter cable will
become slack when the lifter motor unit is removed.
F-3-57
6) Remove the 5 screws [1], and detach the lifter
motor unit [2].
F-3-58
3.3.5.4
Stringing the Lifter
Cable
0009-2110
1) Check to make sure that the lifter drive shaft [1] and
the lifter [2] are fixed in place using a hex wrench
[3] and 2 long screwdrivers [4], respectively.
2) Fix the 4 cable fixing plates [5] in place to the lifter
using 2 screws each.
3) Hook the lifer cable [6] on the 4 pulleys [7] above.
4) Hook the ball of the lifter cable on the 2 front/rear
pulleys [8] of the lifter drive shaft; then, wind it
about 1.5 times along the groove of the pulley.
At this time, be sure to keep the lifter cable taut so that
the long drivers used to keep the lifter are slightly
lifted by the cable.
5) Fix the 2 pulleys [5] in place to the lifter drive shaft
with a set screw [9] (1 pc. each).
6) Fit all removed pulleys to the lifter shaft; then,
measure the height A from the base plate of the
compartment to the top face of the lifter, thus
[1]
[4]
[2]
[3]
[4]
[4]
[3]
[1]
[2]
[4]
[3]
[3]
[1]
[2]
[1]
[1]
[2]