Canon NP6251, Руководство по обслуживанию

Страница: 618 / 812

3. E002
4. E003
5. E004
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
11-87
Cause
Main thermistor
(TH1)
Main thermistor
(TH1)
Environment
Main thermistor
(TH1)
DC controller
Checks
Execute ‘ERROR’ in service mode
(
), and turn on the power
once again. Is either of the
following correct?
•The fixing heater fails to turn on.
•‘E002’ or ‘E003’ is indicated.
Is the contact of the connectors
J108 and J2755, relay connector
J2757, and the connector J2745
inside the fixing assembly good?
Further, is the wiring from the
thermistor to the connector J108
on the DC controller PCB good?
Is the thermistor in even contact
with the upper fixing roller?
Clean the contact area of the ther-
mistor. Is the problem corrected?
Does the problem occur only
when the machine is turned on for
the first time in the morning?
Replace the thermistor. Is the
problem corrected?
]
4
]
Step
1
2
3
4
5
6
YES/NO
YES
NO
NO
YES
YES
YES
NO
Action
Go to the appropriate
section.
Connect them securely.
Install the thermistor
once again.
End.
•Advise the user that the
site is out of
specification.
•Advise the user not to
turn on the machine
until the room is warm
enough.
End.
Replace the DC
controller PCB.
Cause
Fixing heater
AC driver
DC controller
PCB
Checks
Execute ‘ERROR’ in service mode
(
). Does the fixing heater
turn on immediately after power-
on?
Replace the AC driver. Is the
problem corrected?
]
4
]
Step
1
2
YES/NO
NO
YES
NO
Action
See “The fixing heater
fails to operate.”
End.
Replace the DC
controller PCB.