Canon NEW F-1, Руководство по обслуживанию

Страница: 7 / 125

Canon NEW F-1 Service manual
Page 7
Disassembly Notes Assembly and Adjustment Notes
1. Remove the smooth face screw (3)
and shutter button (6) with tool
(CY9-6131-000).
2. Be careful not to lose detent
ball (7)-2 inside the camera.
3. The shutter dial cap (9) is glued in place.
4. Seals (8)(14)(29) and (30) are
available in more than one thick
ness to insure correct sealing.
5. When the rewind crank (22) is not
installed, don't push the rewind
shaft all the way down into its
holder. (If it is, time will be
lost in unnecessary work, because
of the click spring.)
6. Press the opening safety stopper
while removing the left top cover
7. (35).
Assembly and Adjustment Notes
1.
Put Diabond into the winding
lever shaft hole before final
installation of the screw (3).
2.
Lubricate the shutter button
shaft (6) and the interior or
the release lock (7) with GE-C9
[See Water-resistant treatment
(XIX)].
3.
Put Lozoid in the detent groove
of the release lock (7).
4.
Place teflon washer (8) under the lock lever
(7). Use a washer that is 0.3mm thicker than
the "A" dimension shown below. (Water
resistance)
A = l.l-(a-b) mm
Washer t = A +0.3mm
5.
The teflon washer (14) used under the shutter
dial should be 0.1mm thicker than the "B"
dimension shown below. (Water resistance)
B .= 0.5-(a-b)
Washer t = B +0.1mm
6. When installing the shutter dial, align the notch
in (15) and the pin in the shutter dial ring (13)
with the hole in the top cover. The shutter
must be set to "A" before the dial is installed.
Note: Numbers in parentheses in the text correspond to circled
numbers one page 6. Disassemble in normal order and reassemble in
reverse order.