Installing the Camera
22
Installing the Camera
Depending on where you install the camera, you may want to use a commercially available tripod, pantilter,
housing unit or other accessory. The camera is shipped with two TB-1 Tripod Adapter Bases for tripods and
accessories with 0.95 cm (3/8") screws. In addition, the camera body itself is equipped with sockets for 0.64 cm
(1/4") screws.
IMPORTANT
• You can mount the camera on a tripod or similar accessory but do not use
accessories with mounting screws longer than 5.5 mm (0.2 in.).
Tips for Shooting Video
Please note the following at the time of shooting.
IMPORTANT
• Be careful not to obstruct in any way the fan’s air vents.
NOTES
Color bars and audio reference signal
• If the [Camera Setup]
>
[Color Bars]
>
[Activate] setting is set to [On], video output via a network will not
be available.
• You can have the camera output color bars using the following controls or settings.
- Press the BAR button.
- Use the [Camera Setup]
>
[Color Bars]
>
[Activate] setting (
A
Button Operation Guide
).
- When an optional RC-V100 Remote Controller is connected to the camera, you can press the remote
controller's BARS button.
Socket for 0.64 cm (1/4") screws
for attaching a housing unit
Socket for 0.64 cm
(1/4") screws
TB-1 Tripod Adapter Base for tripods
with 0.95 cm (3/8") screws
TB-1 Tripod Adapter Base
for tripods with 0.95 cm
(3/8") screws
5.5 mm (0.2 in.)
