29
ENGLIS
H
•
Use a MHL cable (available on the market) and MHL-HDMI conversion adapter (available on the
market) that comply with the MHL standard. When non-compliant items are used, image
projection may not be possible, or the connected device may malfunction or generate heat.
•
Images may not be displayed correctly depending on the connected device type and the
settings.
•
Operation may differ or the intended operation may not be performed when using the controls
on the projector and the remote controller, depending on the connected device.
•
When using a MHL-HDMI conversion adapter (available on the market), the connected device
cannot be operated using the controls on the projector and the remote controller.
•
When images cannot be projected properly, disconnect and reconnect the MHL cable.
•
Operation is not guaranteed for all connected devices.
Connecting a Component Video source device
Examine your Video source device to determine if it has a set of unused Component Video output sockets
available:
•
If so, you can continue with this procedure.
•
If not, you will need to reassess which method you can use to connect to the device.
To connect the projector to a Component Video source device:
1.
Take a Component Video to RGB (D-Sub) adaptor cable and connect the end with 3 RCA type
connectors to the Component Video output sockets of the Video source device. Match the color of
the plugs to the color of the sockets; green to green, blue to blue, and red to red.
2.
Connect the other end of the Component Video to RGB (D-Sub) adaptor cable (with a D-Sub type
connector) to the
COMPUTER-1
or
COMPUTER-2
terminal on the projector.
3.
If you wish to make use of the projector speaker in your presentations, take a suitable audio cable and
connect one end of the cable to the audio output terminal of the computer, and the other end to the
AUDIO IN
terminal of the projector.
4.
If you wish, you can use another suitable audio cable and connect one end of the cable to the
AUDIO
OUT
terminal of the projector, and the other end to your external speakers (not supplied).
Once connected, the audio can be controlled by the projector On-Screen Display (OSD) menus. See
"Adjusting the sound" on page 47
for details.
The final connection path should be like that shown in the following diagram:
If the selected video image is not displayed after the projector is turned on and the correct video
source has been selected, check that the Video source device is turned on and operating correctly.
Also check that the signal cables have been connected correctly.
AV device
Component Video to
RGB (D-Sub) adaptor
cable (option)
Speakers
Audio
cable
(option)
Audio cable (option)
