40
Basic operation
Power off your projector
1. Press the Power button at the top control
panel or the remote controller, the “Power
off?” message displays.
2. Press the Power button again within 4
seconds after the “Power off?” message
prompted to you. The POWER indicator
flashes red while the cooling fan continues
running. Do not unplug the power cord until
the fan stops running. Failure to do so may
shorten life cycle of your projector or lead
to power on failures or operation abnormali-
ties.
3. The POWER indicator stops flashing once
the projector has been cooled down to
ready for power on again.
To maintain the life cycle of the lamp,
power off your projector after it has
been turn on for at least 5 minutes.
Do not use your projector without
stop. As it may hurt the life cycle of
your lamp. Power off your projector at
least once every 24 hours and have
it idle for an hour.
Power off?
“Power off?” message disappears
in 4 seconds.
Note:
●
If the “Direct Power On” function is set to “On”, your projector will power on once it is con-
nected to an AC power socket. (Refer to
)
●
Speed of the cooling fan varies with internal temperature of your projector.
●
Do not place your projector in any box before it is fully cooled down.
●
In case the Warning indicator flashes or turns red, refer to the “Status light indicator ” for
instructions. (Refer to
●
The POWER indicator flashes when the lamp is cooling down. Do not power on your projec-
tor at this time. Power on your projector only after the POWER indicator turns red.
●
Unplug the power cord after the fan stops running..
!
