Canon iR2270 Series, Руководство по обслуживанию

Страница: 125 / 1008

Chapter 2
2-15
2.2.5 Connecting the Cable
0007-5059
iR2270 / iR2870 / iR3570 / iR4570
1) If you are installing a cassette pedestal, remove the
lattice connector cover, and fit the lattice connector
[1] of the cassette pedestal to the machine.
F-2-40
2) Connect the power plug to the power outlet.
1. Power supply voltage shall be +/-10% of the rating.
2. The amperage of the power supply must be as rated.
3. Before connecting the power plug, check to be sure
that the main power switch is off.
3) Turn on the main power switch.
- The machine issues a message to indicate that it is
loading programs.
- The machine issues a message to indicate that its
printer is getting ready for a job.
Turning Off the Main Power
Whenever you have to turn off the main power, be
sure to go through the following to avoid damage to
the hard disk:
1. Hold down the control panel power switch for 3 sec
or more.
2. Go through the instructions for the shut-down
sequence shown on the display so that the main power
switch may be turned off.
3. Turn off the main power switch.
2.2.6 Stirring Toner
0007-5062
iR2270 / iR2870 / iR3570 / iR4570
1) Enter the Service Mode. (Press "*" first, and "2"
and "8" at the same time, and then "*.")
2) Select COPIER >FUNCTION > INSTALL>
TONER-S.
3) Press the OK key.
- Toner stirring time is approx. 6 minutes. After
counting up, it stops automatically.
- Make the cassette settings before toner stirring is
completed. (See Setting the Cassettes.)
2.2.7 Setting the Cassettes
0007-5065
iR2270 / iR2870 / iR3570 / iR4570
1) Press the cassette release button, and draw out the
cassette to the front.
2) Check the paper series that the user is going to use,
and verify whether or not the paper series selection
switch [1] in the cassette matches that of the user's
selection. If not, change the paper size series to the
appropriate one.
3) Set the paper size selection dial [2] to the paper size
of the paper to be placed.
[1]