Canon iPF830 Series, Основное руководство

Страница: 129 / 146

Cause Corrective Action
Paper can be retracted only up to 17 mm (0.7 in) when using the Media
Take-up Unit. Canceling manual advancing.
Rel lever is in wrong position.
Rel lever is in wrong position.
Cause Corrective Action
The Release Lever is up. Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Rewinding error.
Rewinding error.
Cause Corrective Action
There is some foreign object near the Media Take-up Unit sensor and the
roll cannot be detected. Remove the foreign object near the sensor.
The roll is out of range of detection by the Media Take-up Unit sensor. Reload the roll.
Press the
OK button to clear the error.
(See "Loading Rolls in the Printer.")
➔
P.15
(See "Using the Media Take-up Unit.")
➔
User's Guide
A paper jam has occurred and the roll cannot be rewound. Remove the paper from the Media Take-up Unit.
Press the
OK button to clear the error.
The Media Take-up Unit sensor is damaged. Contact your Canon dealer for assistance.
*1: Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to stop, set Skip
Take-Up Err to On . However, note that this error may cause paper jams and affect the printing quality.
Media take-up unit ready.
Media take-up unit ready.
Cause Corrective Action
The Take-up Reel setting in the printer Set./Adj. Menu
was changed from Enable to Disable , but a print job
was received before the roll was removed.
Press ▲ or ▼ to select Stop Printing , and then press the OK button to
stop printing.
The mode switches from take-up mode to regular mode after you change
the
Take-up Reel setting in the Set./Adj. Menu from Enable to Disable
and lift the Release Lever to remove a roll, or after you execute Paper
Cutting .
Press ▲ or ▼ to select Print , and then press the OK button to resume
printing.
Turn on the media take-up unit.
Turn on the media take-up unit.
Cause Corrective Action
The Take-up Reel setting in the control panel menu was changed to Enable while the power
to the Take-up Reel was off and the Roll Media lamp on the control panel was lit.
Turn the Media Take-up Unit on.
The Take-up Reel setting in the
control panel menu changes to
Disable .
Borderless printng not possible.
Borderless printng not possible.
Cause Corrective Action
The print job received specifies
a type or width of paper that is
not compatible with borderless
printing. Follow these steps to change the settings of the print job to enable borderless printing.
1.
Press ▲ or ▼ to select Stop Printing , and then press the OK button.
2.
Make sure the correct printer driver for the printer is selected and try printing again.
For information on types of paper compatible with borderless printing, refer to the
Paper Ref-
erence Guide .
(See "Displaying the Paper Reference Guide.")
➔
User's Guide
iPF830 Series Rel lever is in wrong position.
Basic Guide
Error Message
Messages regarding paper
129