Canon Inner Finisher-L1, Руководство по обслуживанию

Страница: 105 / 128

Items Service Mode
(SORTER> OP-
TION)
Use case Remarks
To set whether to suspend deliv-
ery when it is detected that the Fin-
isher Tray is full TRY-STP Upon user's request
To set whether to stop the ma-
chine when an error occurs at Fin-
isher MD-SPRTN When preferring to run the machine although an
error occurs at Finisher
To set the duration of time before
executing automatic stapling at
manual staple mode MSTP-TMG Upon user's request
To set the staple position of staple
free stapling FR-ST-PO Upon user's request
To set the staple-free stapling
without staple cartridge FR-ST-SW Upon user's request
To set the duration of time to keep
manual staple mode enabled after
execution of manual stapling MSTP-WT Upon user's request
To set the tray position after the
completion of job TRY-PSTN Upon user's request (to improve visibility of the
delivered paper)
To set the start timing of paper re-
tainer operation RET-TMG When a paper stack is discharged to a position
that cannot be reached by the paper retainer and
stacking failure occurs due to the paper stack be-
ing pushed out by the next paper stack.
Set assist guide operation start
timing ASTG-TMG When the stack delivery failure occurs.
Switching the high-productivity
punch mode or high-accuracy
punch mode of the inner puncher
unit PUCH-SW When switching the high-productivity punch mode
or high-accuracy punch mode. This mode is available when
the inner puncher unit has
been installed.
To set whether to perform the hor-
izontal registration operation of the
inner puncher unit for matching
with the center of the paper PUN-Y-SW When the adjustable range of the punch hole hor-
izontal registration adjustment is enlarged.
To set the punch hole specification
of the inner puncher unit PNCH-SW2 When replacing the Puncher Controller PCB.
Basic Adjustment Items
No Items Use case Refer to
1
Adjusting the
Alignment
Adjusting the Alignment Posi-
tion at Staple Mode When the paper alignment position is displaced in the
staple mode or staple-free staple mode.
“Adjusting the Alignment
Position at Staple Mode”
on page 101
2
Adjusting the Alignment Posi-
tion at Non-staple Mode When the paper stacking position is displaced in the non-
sort mode or shift-sort mode.
“Adjusting the Alignment
Position at Non-staple
Mode” on page 102
3
Adjusting the Return Belt
Pressure
When misalignment occurs in feed direction.
“Adjusting the Return
Belt Pressure” on page
102
4
Adjusting Center Alignment
Standard Position
• When the standard position for the center alignment
is misaligned.
• When misalignment occurs in front/ rear direction.
“Adjusting Center Align-
ment Standard Position”
on page 103
5
Right Angle Adjustment of
Alignment Plate • When remove or replace the Alignment Plate.
• When the paper alignment position is displaced.
“Right Angle Adjustment
of Alignment Plate ” on
page 104
6
Adjusting the
Staple Position
Adjusting the Staple Position
When the staple position in front/rear direction is dis-
placed in the front/rear 1-stapling mode or 2-stapling
mode.
“Adjusting the Staple
Position ” on page 108
5. Adjustment
98