Canon imageRUNNER ADVANCE C3500 III Series, Руководство по обслуживанию, Страница: 1175 / 1252

6
Turn ON the main power switch.
CAUTION:
If the machine does not recognize this equipment,
unplug and then plug the power plug after turning OFF
the main power switch, or turn OFF the main power
switch and then turn it ON within 20 seconds. To avoid
this symptom, unplug the power plug or turn the
breaker OFF when installing.
NOTE:
When a message prompting to turn OFF and then ON the
main power appears, turn OFF and then ON the main
power switch.
Operation Check
■ Type Settings
1.
This setting performs the parameter settings to match
the communication specification of the country/region.
Set the TYPE of country/region to install this machine,
and then press OK.
• FAX > Type > TYPE
2.
Confirm that service mode parameter below is "0". In the
case, parameter is "1", change to "0".
COPIER > OPTION > DSPLY-SW > SDTM-DSP
NOTE:
Change the parameter to "0" to hide [Settings/
Registration] > [Preferences] > [Timer/Energy Settings]
>[Auto Shutdown Time] and disable the auto shut down.
3.
Turn OFF/ON the main power switch to enable this
setting.
■ Basic Setting
NOTE:
When "System Manager Information Settings" is set, be
sure to follow the direction of user administrator in order
to log in as an administrator.
In this section, make only minimum settings required for FAX
communication.
1. Set the user telephone number.
[Settings/Registration] > [Function Settings] > [Send] >
[Fax Settings] > [Set Line] > [Line 1] > [Register Unit
Telephone Number] > Enter the fax number > [OK]
2. Set Type of telephone line.
[Settings/Registration] > [Function Settings] > [Send] >
[Fax Settings] > [Set Line] > [Line 1] > [Select Line Type]
> Select the line type to connect > [OK]
3. Turn OFF/ON the main power switch after setting the
user telephone numbers and the type of telephone
line.
■ Fax communication test
Perform the communication test to check if FAX function
works Correctly.
1. Switch the control panel display to [Fax] display.
2. Send the test document from this machine to
another machine that can handle the
communication test to check that this machine can
send the data correctly.
3. Send the test document from the target to this
machine to check if the machine can receive the
document properly.
9. Installation
1153