Canon imageRUNNER ADVANCE C3330 Series, Руководство по устранению неисправностей, Страница: 185 / 200

Copier Color | iR-ADV C2230/C2225/C2220 Series |
Copier Color | iR-ADV C3330/C3325/C3320 Series |
Copier Color | iR-ADV C5051/C5045/C5035/C5030 Series |
Copier Color | iR-ADV C5255/C5250/C5240/C5235 Series |
Copier Color | imagePRESS C800/C700/C60 Series |
Copier Color | imagePRESS C850/C750/C650 Series |
Points to note when replacing timing belt set of the operation tray
assembly (Staple/Booklet Finisher-C1/J1/M1/T1/U1)
[Detail]
If the claws attached to the cogged timing belt (FC5-3553-000) are detached due to the insufficient strength, the back end assist
button (FC5-4715-000) and the back end assist plate (4F8-0088-000) are also detached, and the printed paper cannot be output,
which may cause E514-8001 error.
As measures against it, the shapes of the following parts [1]to[3] are changed.
1. Timing belt [1]
2. Back end assist button [2]
3. Back end assist plate [3]
As a result, if any one of the above parts is changed, all the 3 parts need to be changed simultaneously.
[Service work]
If changing any one of the timing belt [1], the back end assist button [2] and the back end assist plate [3], prepare the timing belt
set (4Y8-3107-000), which is composed of the new-type parts, and replace the 3 parts simultaneously by following the steps
below.
The following steps describe the steps after the finisher is separated from the copier.
1) Remove the operation tray by referring to Service Manual.
2) Pull the operation tray adjuster guide (front) [1], the operation tray guide (front) [2], the operation tray guide (rear) [3], and the
operation tray adjuster guide (rear) [4] of the operation tray assembly in the arrow direction to remove.
180