Canon imageRUNNER ADVANCE 6075 Series, Руководство по обслуживанию, Страница: 860 / 1406

8
8
8-78
8-78
Service Mode > COPIER > ADJUST > DENS
Service Mode > COPIER > ADJUST > DENS
■
DEVELOP
COPIER > ADJUST > DEVELOP
BIAS Adjustment of developing bias
Lv.1 Details To adjust the developing bias when the potential control is not
performed.
Use case When potential control is not performed
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 600
Default value 180
TSPLYADJ [Not used]
Lv.2 Details -
T-8-29
■
DENS
COPIER > ADJUST > DENS
DENS-ADJ Density correction of copy image
Lv.1 Details To correct the density of copy image by changing the F-value table.
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Blurring is alleviated when the value is increased, and fogging is
alleviated when the value is decreased.
Use case When fogging or blurring at high density area occurs with a copy
image
Adj/set/operate method Enter the setting value, and then press OK key.
Caution
Density of printer output image cannot be corrected.
Display/adj/set range 1 to 9
Appropriate target value 4 to 6
Default value
5
Supplement/memo F-value table: shows the relationship between original density and
image density.
T-8-30