Canon imageRUNNER 5065 series, Руководство по обслуживанию

Страница: 68 / 596

Chapter 2
2-12
F-2-45
2) Attach the cleaning procedure labels [1] [2] for the relevant language.
F-2-46
3) Remove the reading cleaning tool [1].
F-2-47
4) Attach the cleaning procedure label [1] for the relevant language.
F-2-48
5) Put the detached parts back on by reversing the foregoing steps.
- Reading cleaning tool
- White sheet
6) Close the DADF.
2.2.13 Connecting the Power Cord
0015-9944
iR5065 / iR 5055 / iR5075 / / /
1) Connect one side of the power cable to the inlet of the host machine, and
the other side to the plug outlet.
2.2.14 Turning On the Main Power Switch
0015-4668
iR5065 / iR 5055 / iR5075 / / /
1) In the case of 100V machine, ground the host machine with the grounding
wire.
Targets of Grounding
1. Grounding terminal of power outlet
2. Grounding terminal of which grounding work (D Type) is properly
done.
2) Slide the duplexing unit out, and check to see that there is no foreign
substances or damage in the unit.
3) Make sure that the main power switch is turned off, and then connect the
power plug into the power outlet.
4) Turn on the main power switch.
- The message 'Wait..' appears.
2.2.15 Toner Stirring
0015-4669
iR5065 / iR 5055 / iR5075 / / /
After wait time, execute toner supply in service mode.
1) Enter service mode.
2) Select: COPIER > FUNCTION > INSTALL > TONER-S.
3) Check the message 'CHECK THE DEVELOPER' appears.
4) Check to see that the developing assembly is attached appropriately, and
then press 'OK'.
- It takes approx. 8 to 10 minutes to supply toner. The machine stops
automatically after counting.
- Make settings for the cassette until the completion of toner supply. (See
media cassette settings.)
5) Press [Reset] to escape from service mode.
2.2.16 Media Cassette Settings
0015-4671
iR5065 / iR 5055 / iR5075 / / /
1) Hold down the cassette release button to slide each cassette to the front.
2) Set the side guide [1] of each cassette onto the hole of the mark M [2] (A4/
A3).
F-2-49
3) Attach the inch-series block from inside the cassette onto the hole of the
mark A [1] (STMT-R) and the hole of the mark H [2] (LTR-R) so that
they are hidden.
F-2-50
4) Close each cassette.
[1] [2]
[A]
[1]
[2]
[1]
[1]
Be sure to remove the packaging materials inside the cassette before turning
on the main power switch.
Be sure not to turn off the machine during its operation.
-Be sure to attach the inch-series block firmly.
-Go through this procedure only in case of not using inch-series paper.
[1]
[2]
[1]
[2]