Canon imageRUNNER 2545, Руководство по обслуживанию

Страница: 189 / 362

6
6
6-6
6-6
■
Too Large Curl
[Occurrence area]
Fixing assembly
[Cause]
The water content on the front surface of paper becomes different from that on the reverse
side of paper, making the curl larger.
[Occurrence condition]
When the paper has been left alone in a high-humidity environment.
[Remedy]
USER MODE> Adjustment/ Cleaning> Manual> Special Mode N> Medium or High
*Normally, select "Low". Selecting "High" will reduce productivity.
Machine shipped with cassette heater: Turn on the heater.
Install an optional cassette heater.
■ Thin Paper Jam (63g/cm2 or Less)
[Occurrence area]
Drum
Fixing assembly
[Cause]
The separation power reduces due to low elasticity of paper, causing a jam in the cleaner or
fixing assembly.
[Occurrence condition]
When paper thinner than 64g/cm2 paper is used.
[Remedy]
USER MODE> Adjustment/ Cleaning> Manual> Special Mode P> Medium or High
* When 52g/cm2 paper is used, "High" must be selected.
■
Paper Jam due to Solid Image Printed on Paper with Small
Leading-Edge Margin (1-4 mm)
[Occurrence area]
Fixing assembly
[Cause]
When a solid image is printed on the paper with a small leading-edge margin (1-4 mm), paper
cannot be easily separated from the fixing film, causing a paper jam.
[Occurrence condition]
When the paper has been left alone in a high-humidity environment or when a solid image is
printed on the paper with a small leading-edge margin.
[Remedy]
USER MODE> Adjustment/ Cleaning> Manual> Special Mode O> Medium or High
USER MODE> Adjustment/ Cleaning> Manual> Special Mode N> High
*Selecting "Special Mode O" or "Special Mode N>High" will increase the leading-edge margin
and consequently prevent a paper jam due to improper separation.
*Selecting "Special Mode N>High" will make the curl smaller but reduce the productivity.
■
Cannot Turn the Toner Bottle Set Lever or Hard to Turn it
[Occurrence area]
Toner bottle set lever
[Cause]
When the toner bottle cap is largish while it is sealed to the specification, more power may be
required to turn the lever for opening/closing the cap.
The toner bottle is not pushed until it clicks.
[Occurrence condition]
When the newly opened toner bottle cap is largish while it is sealed to the specification.
When an attempt to set the bottle containing toner has been repeated unnecessarily.
[Remedy]
After turning the toner bottle set lever about 45 degrees, turn the set ON lever while pulling
out the toner bottle. This is the way to set the toner bottle easily.
Push the toner bottle all the way in, and then turn the lever.