Canon imagePROGRAF iPF6200, Руководство по обслуживанию

Страница: 269 / 692

Chapter 2
2-89
2.5.6 Carriage system
0016-8206
iPF6100 / iPF6200 / iPF6000S / iPF6300 / iPF6350 / iPF6300S
F-2-94
Multi sensor
The photo-reflection-type multi sensor is composed of four LEDs (red, blue, green and infrared) and two light-sensitive sensors. It detects the leading edge, skewing,
and width of media and is used for adjustment of the registration, head height, and color calibration.
During head adjustment, the light reflected by the infrared LED and green LED is detected by two light-sensitive sensors to calculate the head height from the
difference between the measurements.
When color calibration is executed, a color chart printed is read with three-color LED (red, blue, green), so color correction is implemented on the basis of the
readings.
Ink mist adhering to the sensor could deliver incorrect measurement readings when color calibration is executed. If the ink dot count exceeds a tolerance, the service
error (E194-4034) would occur. If it does, execute service mode: SERVICE MODE > ADJUST > GAP CALIB. after the multisensor has been replaced to clear the
dot count.
F-2-95
- Service mode: After SERVICE MODE > ADJUST > GAP CALIB. has been carried out, pass paper to make sure that it is detected properly.
- In executing Calibration concurrently with the main menu choice Auto Head Adj. or Manual Head Adj., Auto Head Adj. or Manual Head Adj. first for the sake
of higher color calibration accuracy.
Linear encoder sensor
When the carriage moves, the linear encoder sensor located at the rear of the carriage reads the slits on the linear encoder to detect the carriage position.
Lift cam sensor
Linear encoder sensor
Multi sensor
Platen
Media
Infrared LED
LED(red) LED(green) LED(blue)
Infrared sensor