Instructions for replacing the print head for the imagePRGRAF PRO1000
[
Prior
information
]
•
Ink and maintenance cartridge capacity is consumed by replacing the print head.
Preparing the ink tank and maintenance cartridge to replace in advance is recommended.
•
Once you begin working on replacing it, you cannot use any other function until it is completed.
•
The bag of print head should not be opened until right before installing to the printer.
[
Procedure
]
1. Press the ON button to turn on the printer.
2. Open the top cover when the power lamp is lit.
3. Press and hold the STOP button for five seconds or longer. Release the STOP button when the message,
“Processing… Please wait momentarily.” is displayed on the LCD screen. Wait until the print head holder
comes to the head replacement position. (
For approx. 5 minutes)
[IMPORTANT]*1:
While waiting for 5 minutes, please do not touch the cover and buttons etc.
4. When the print head holder stops at the head replacement position, follow the instructions displayed on the
LCD screen to remove the print head.
-> Press the
OK
button after removing the print head.
[IMPORTANT]*2:
Ink may adhere to the nozzles of the removed print head. Please take extra care when
handling the print head.
5. Take the new print head out from the pillow bag
,
holding the handle of the print head, then, remove the two
orange protective caps.
[IMPORTANT]*3:
Please make sure to hold the handle of the print head. Do not touch any other part
except the handle.
7. Follow the instructions displayed on the LCD to install the print head.
8. Close the top cover
. I
nk filling will start. (
For approx. 20 minutes
)
[IMPORTANT]*1:
While waiting for 20 minutes, please do not touch the cover and buttons, etc.
When the ink filling is completed, the confirmation screen is displayed. Follow the instructions displayed on
the LCD screen to perform the print head alignment.
For performing the print head alignment, three sheets of A4 size or Letter size paper are needed.
Handle
Do not touch
