Canon imagePRESS C1+, Справочное руководство, Страница: 358 / 622

Device Management Settings 6-74
6
Syste
m
Man
age
r Set
ti
ngs
Full Adjustment
The following two types of full gradation adjustments can be made:
■
S Printer
This gradation adjustment is performed by outputting a test print and scanning it repeatedly (3 times).
Although user operation is required for scanning the test print, this adjustment takes a relatively short
time to complete, and only three sheets of paper are consumed.
■
Printer Only
In this gradation adjustment, the output test print is automatically scanned 10 times. Although user
operation is not required in the process, it takes a longer time compared to selecting [S Printer]
for gradation adjustment, and ten sheets of paper are consumed.
This section describes the procedures if [S Printer] is selected for gradation adjustment. If
[Printer Only] is selected, setting the output test print onto the platen glass is not required.
IMPORTANT
•
[S Printer] appears only if the optional Color Image Reader-H1 is attached to the machine.
•
This machine adjusts the toner and print speed according to the paper type. To make effective
adjustments, select the correct paper type.
•
Make sure that you place the test prints properly. Accurate recalibrations of the gradation, density, and
colour settings of the machine cannot be made if the test prints are not scanned correctly.
•
It is recommended that you use Canon High Grade (100 g/m 2 ) (MONDI BUSINESS PAPER Holding) for
a test print. Calibrations are made based on the output test print. If the paper used for a test print is not
one that is specified for test printing, tone adjustment may not be performed correctly.
•
When performing full adjustment, three sheets of test print ([S Printer] is selected) and ten
sheets of test print ([Printer Only] is selected) are output. Make sure that A3 or 11" x 17" paper is loaded
into the machine before starting this procedure.
NOTE
Test prints are not counted as part of the copy or print total page counts.