17
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Perform the following steps to set up the CR-190i. Refer to the section
for each step for details about that step.
A
Check your operating environment. (See “Checking Your
Operating Environment,” on p. 18.)
B
Install the software. (See “Installing the Software,” on
p. 19.)
Install the Scanning Utility provided with the CR-190i.
C
Connect the scanner to a computer. (See “Connecting
the Scanner to a Computer,” on p. 20.)
D
Turn ON the power. (See “Turning ON the Power,” on
p. 21.)
E
Automatically installing the device driver. (See p. 22.)
The device driver is installed automatically when Windows
recognizes the CR-190i.
IMPORTANT
•
To have the device drivers installed automatically when the computer
recognizes the CR-190i, the software needs to be installed before the
CR-190i is connected to the computer.
•
If you connect the computer and turn ON the CR-190i before installing the
software, the following wizard screen appears. If this happens, click
[Cancel], turn OFF the CR-190i, and then install the software.
The following wizard screen is an example in Windows Vista. When a
similar wizard screen appears in Windows XP/7, click [Cancel].
Setting Up the Scanner
Wizard Screen (Windows Vista)
Содержание imageFORMULA CR-190i
Страница 1: ...Please read this manual before operating this scanner Instructions...
Страница 40: ...40 G Close the Front Maintenance Cover in the order shown in the diagram below...
Страница 56: ...56 J Close the Feed Supporter to the right K Replace the Roller Cover L Carefully replace the Top Cover...
