Canon imageCLASS X LBP1238, Руководство по обслуживанию

Страница: 159 / 220

E015-0000-- Main Motor error
Detection Description An error was detected in the Main Motor.
Remedy
1. Check the harness/connector between the Main Motor (M701) and the Low Voltage Power
Supply PCB (UN2).
2. Check the harness/connector between the Low Voltage Power Supply PCB (UN2) and the
Engine Controller PCB (UN1).
3. Replace the Main Motor (M701).
4. Replace the Low Voltage Power Supply PCB (UN2).
5. Replace the Engine Controller PCB (UN1).
E020-0000-- Error in Color Displacement/Density Sensor
Detection Description An error in the Color Displacement/Density Sensor was detected.
Remedy 1. Check the harness/connector between the RD Sensor (UN3) and the Engine Controller PCB
(UN1).
2. Replace the RD Sensor (UN3).
3. Replace the Engine Controller PCB (UN1).
E052-0000-- Duplex Feed Unit absent error
Detection Description The connection of the Duplex Feed Unit was not correct.
Remedy 1. Replace the Engine Controller PCB (UN1).
E066-0000-- Environment Sensor error
Detection Description An error in the Environment Sensor was detected.
Remedy 1. Check the harness/connectors between the Environment Sensor (UN10) and the Engine
Controller PCB (UN1).
2. Replace the Environment Sensor (UN10).
3. Replace the Engine Controller PCB (UN1).
E110-0000-- Pseudo BD detection error
Detection Description The error is detected when the completion of pseudo BD measurement is not notified within the
specified period of time after the pseudo BD generation.
Remedy 1. Check the harness/connector between the Laser Scanner Unit and the Engine Controller PCB
(UN1).
2. Replace the Laser Scanner Unit.
3. Replace the Engine Controller PCB (UN1).
E196-0000-- DC Controller error
Detection Description The update of the DC Controller failed.
Remedy 1. Install the set of controller firmware.
2. Replace the Engine Controller PCB (UN1).
E196-1000-- ROM writing/reading error (Main ROM)
Detection Description Error in writing/reading of main program in the Main Controller PCB (Main ROM).
Remedy 1. Update the firmware.
2. Replace the Main Controller PCB (UN30).
E196-2000-- ROM writing/reading error (ROM for storing setting values)
Detection Description Error in writing/reading of the setting values storage area in the Main Controller PCB (ROM for
storing setting values).
Remedy
1. Update the firmware.
2. Replace the Main Controller PCB (UN30).
E196-3000-- ROM writing/reading error (eMMC)
Detection Description Unable to read/write data from the eMMC.
The eMMC failure occurred.
Remedy 1. Update the firmware.
2. Replace the Main Controller PCB (UN30).
8. Error/Jam/Alarm
149