1
2
3
4
5
6
3-22
■
Advanced Mode – Specifying the
Parameters of a Scan
You can create scan areas (cropping areas) for images shown in
the Preview Area. When you click [Scan], only the cropped area
will be scanned.
Selecting the Cropping Area Automatically
After previewing, click
(Auto Crop) on the toolbar. Clicking
this button enables you to gradually crop off the image outside
the borders detected in the preview image.
Creating a Cropping Frame
Click
(Crop) on the toolbar, click on the preview image and
drag over the area you wish to select. To make further
adjustments, drag the corner or edge of the selected frame or
enter the desired parameter values for
(Width) and
(Height) in [Input Settings]. To move the cropping frame you
have selected, click inside the cropping frame and drag.
NOTE
To maintain the current width and height proportion of the image, click
in [Input Settings].
Creating Multiple Cropping Frames
You can create another cropping frame even if there is already
one in the Preview Area. Click and drag the mouse cursor
outside the existing cropping frame to create a new cropping
frame in that area.
You can create up to 10 cropping areas. By clicking [Scan] once,
all the cropped areas will be scanned. (Scanning will continue
until all selected areas have been scanned.)
The most recently created cropping frame will become the focal
point. To make adjustments to previously created cropping
frames, select the frame or frames by clicking on them.
