Canon image RUNNER 3245, Руководство по началу работы, Страница: 108 / 180

NetWare Network Setup Procedures 6-2
6
Using a NetWare Network (Windows)
NetWare Network Setup Procedures
To use a NetWare network, it is necessary to perform the following procedures.
1
NetWare Print Service Settings (See e-Manual > Network)
Specify the NetWare print service settings. (Optional equipment is required to print or send a fax from a computer. For the equipment
needed, see “Optional Equipment and System Requirements for Connecting to a Network,” on p. 3-2.)
To specify the settings from the computer, use:
NWADMIN or PCONSOLE (Novell software provided with NetWare)
Canon utilities (NetSpot Device Installer, etc.)
•
•
2
Protocol Settings (See “Protocol Settings,” on p. 6-3.)
Specify the protocol settings. To specify the settings, use:
The machine's control panel
The Remote UI (via a web browser)
Canon utilities ( NetSpot Device Installer, etc.)
•
•
•
3
Computer Settings for Printing/Sending a Fax (See e-Manual > Network)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to print or send a fax from a
computer. For the equipment needed, see “Optional Equipment and System Requirements for Connecting to a Network,” on p. 3-2.)
4
Computer Settings for a File Server (See “Setting Up a Computer as a File Server,” on p. 6-7.)
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to send data if you are using
the imageRUNNER 3245/3235/3230/3225. For the equipment needed, see “Optional Equipment and System Requirements for Connecting
to a Network,” on p. 3-2.)
It is recommended that steps 1, 2, and 4 above be performed by the network administrator.
To configure settings with software other than the control panel of the machine, NWADMIN, PCONSOLE, or NetSpot
Device Installer, TCP/IPv4 protocol must be supported by your network environment (IPv6 is not supported).
•
•