Canon Finisher-AB1, Руководство по обслуживанию

Страница: 114 / 463

Chapter 5
5-8
Make sure that the total of the indexes over which the
latch base (front, rear) is moved is between -2 and +2
mm.
F-5-18
4) Remove the middle rear cover [1].
- 4 screws [2]
F-5-19
5) Loosen the 2 screws [2] on the latch base (rear)
[1].
6) If the value recorded is on the + side, move the
base in the direction of [A] and tighten the screw
[2].
If the value recorded is on the - side, on the other
hand, move the base in the direction of [B] and
tighten the screw [2].
Make sure that the total of the indexes over which the
latch base (front, rear) has been moved is between -2
and +2 mm.
F-5-20
7) Connect the finisher and the host machine.
8) Turn on the finisher and the host machine in
sequence.
9) Check the adjustment values once again.
If the adjustment value indicated by the LED is
within a specific range, press the ENTER key to
end adjustment mode. Otherwise, go through the
steps for a second time; if the result is more or less
the indicated value (reference only), end the
work.
10) Put the DIP switch back to its initial settings, and
attach the covers and parts you have removed.
5.3.1.3 Adjusting the Sensor Intensity
0015-2224
Go through the following steps when installing the
finisher or replacing specific sensor:
1) Turn on the finisher and the host machine in
sequence.
2) Open the front cover, and insert the door switch
actuator into the door switch [1].
[B] [A]
[1]
[2]
[2]
[2]
[1]
[B] [A]
[1]
[2]