Canon F-1, Руководство по обслуживанию

Страница: 140 / 179

5
5
5-6
5-6
Adjustments > Adjustment Method > Measurement during Reader Controller PCB Replacement and After RAM Clear
Adjustments > Adjustment Method > Measurement during Reader Controller PCB Replacement and After RAM Clear
8) Perform output adjustment of the sensor.
CAUTION:
Be sure that there is no paper inside the DADF.
8-1) Perform service mode item.
Lv. FEEDER > FUNCTION >
1 SENS-INT
9) Adjust tray width. Perform either AB system or Inch system.
a. AB system adjustment.
a-1) Select the item in the service mode.
Lv. FEEDER > FUNCTION >
1 TRY-A4
a-2) Adjust the slide guide to the index “A4/A3”.
a-3) Press OK, and register the A4 width.
a-4) Select the item in the service mode.
Lv. FEEDER > FUNCTION >
1 TRY- A5R
a-5) Adjust the slide guide to the index “A5R”.
a-6) Press OK, and register the A5R width.
b. Inch system adjustment.
b-1) Select the item in the service mode.
Lv. FEEDER > FUNCTION >
1 TRY-LTR
b-2) Adjust the slide guide to the index “LTR/ 11x17”.
b-3) Press OK, and register the letter width.
b-4) Select the item in the service mode.
Lv. FEEDER > FUNCTION >
1 TRY- LTRR
b-5) Adjust the slide guide to the index “STMT/ LTRR/ LGL”.
b-6) Press OK, and register the LTRR width.
T-5-10
T-5-11
T-5-12
T-5-13
T-5-14
10) After turning OFF/ON the power, make a copy and check the copied image.
If moiré appeared on the copied image, perform the sharpness adjustment in service mode.
a. Reader
Lv. COPIER > ADJUST > MISC >
1 SH-ADJ
b. DADF
Lv. COPIER > ADJUST > MISC >
1 SH-ADJ2
11) Make an output of P-PRINT.
Lv. COPIER > FUNCTION > MISC-P >
1 P-PRINT
12) Store the outputted P-PRINT into the service book.
T-5-15
T-5-16
T-5-17