Canon EOS C300 Mark II, Инструкция по эксплуатации

Страница: 43 / 223

43
Preparing the Camera
Removing and Attaching the Grip Unit
The grip unit comes originally attached to the camera. You can remove it and replace it with the thumb rest
should the minimal configuration be necessary.
Removing the Grip Unit
1 Set the
Q
switch to OFF.
2 Unscrew the grip unit’s lock screw and gently detach
the grip unit.
• The grip unit contains an internal connection cable
so be sure not to pull it too forcefully.
3 Disconnect the grip unit’s connection plug.
4 Screw the thumb rest onto the camera.
Attaching the Grip Unit
The grip unit can be attached in any of 24 positions (at
15º intervals) to give you a convenient grip angle for
high- and low-angle shooting.
1 Set the
Q
switch to OFF.
2 Unscrew the thumb rest and remove it from the
camera.
3 Firmly insert the grip unit’s plug all the way into the
grip unit connection terminal on the camera.
• Make sure to insert the plug all the way in, until the
white line around the terminal is not visible.
• If the plug is not correctly connected (for example, if
the white line around the terminal is partly visible), all
the controls on the camera may be disabled.
4 Attach the grip unit to the camera aligning it at the
desired angle and tighten the grip unit’s lock screw.
Adjusting the Grip Belt
Adjust the grip belt so that you can reach the START/STOP button on
the grip unit with your index finger but still have a comfortable but
secure grip.
햳
햴
햵
햳
햴
햵
White line