Canon EOS C100 Mark II, Инструкция по эксплуатации

Страница: 90 / 214

Recording Audio
90
Adjusting the Microphone’s Sensitivity
You can adjust the microphone’s sensitivity if the XLR terminal switch is
set to MIC or MIC+48V.
1 Open the desired XLR terminal’s sensitivity submenu.
[
¡
Audio Setup]
>
[Audio Input]
>
[XLR1 Mic Trimming] or [XLR2
Mic Trimming]
2 Select the desired level and then press the joystick.
Available sensitivity levels
Activating the Microphone’s Attenuator
You can activate the microphone’s attenuator (20 dB) if the XLR terminal
switch is set to MIC or MIC+48V.
1 Open the desired XLR terminal’s microphone attenuator submenu.
[
¡
Audio Setup]
>
[Audio Input]
>
[XLR1 Mic Att.] or [XLR2 Mic
Att.]
2 Select [On] and then press the joystick.
Monitoring the Audio with Headphones
Connect headphones* with a
∅
3.5 mm stereo mini-plug to the
×
(headphone) terminal to monitor the recorded audio. You can adjust
the headphone volume with the [
¡
Audio Setup]
>
[Audio Output]
>
[Headphone Volume] setting.
* For 50.00 Hz recordings, use commercially available headphones with a cable no
longer than 3 m.
NOTES
• If you set an assignable button to [Hea] or [Headphone -]
(
A
107), you can press the button to adjust the headphone
volume without using the menu.
• When you are monitoring the audio, you can choose to synchronize
the audio signal with the video signal or monitor the audio in real
time. Use the [
¡
Audio Setup]
>
[Audio Output]
>
[Monitor
Delay] setting to select the method.
+12 dB +6 dB 0 dB -6 dB -12 dB
[
¡
Audio Setup]
[
Audio Input]
[XLR1 Mic Trimming]
[XLR2 Mic Trimming]
[0 dB]
[
¡
Audio Setup]
[Audio Input]
[XLR1 Mic Att.]
[XLR2 Mic Att.]
[Off]
×
(headphone)
terminal
COP
Y