Canon dp-v3010, Инструкция по эксплуатации

Страница: 49 / 102

49 OSD Menu
Channel Settings
This menu is used for input related settings. Select the "Select Channel" item and choose a channel number from CH1
to CH30. Finally define the parameter of each of the "Channel Settings".
Item Setting Options (underline indicates factory default)
Select Channel Displays the channel number. In addition, you can assign each content of "Channel Settings" to each
channel (
50).
CH1
to
CH30
Note
• It may take 10 seconds when switching channels.
Input Configuration Select the input. Factory default depends on the channel ( 50).
3G/HD-SDI 1, 3G/HD-SDI 2, Dual Link HD-SDI, DisplayPort, — (Not set)
Select Input Signal Sets the signal display method ( 16).
Automatic : "4K Input" and "Single Input" are automatically determined.
4K Input : Displays the signal transmitted over four inputs.
Single Input : Displays the signal of a single input onto the center of the screen. Select from A to D.
Format Sets the color format and gradation.
Automatic, 4:2:2 YCbCr 10-bit, 4:2:2 YCbCr 12-bit, 4:4:4 YCbCr 10-bit,
4:4:4 YCbCr 12-bit, 4:4:4 RGB 10-bit, 4:4:4 RGB 12-bit, 4:4:4 XYZ 12-bit
Note
• HD-SDI is fixed to "4:2:2 YCbCr 10-bit".
• DisplayPort is fixed to "Automatic".
• Operations when "Automatic" is selected are described below:
-
When "4K Input" is selected, they are rendered in a Payload that is selected in the order of
priority A
→
B
→
C
→
D in the display area.
-
When receiving 3G-SDI or Dual Link HD-SDI input, all signals without a payload format will
be rendered in "4:4:4 RGB 10-bit".
Internal Sync Synchronizes four inputs for "4K Input".
On : Force synchronization.
Off : Do not force synchronization.
Channel Name Sets the name of the selected channel. You can input up to 16 alphanumeric characters.
Picture Mode Sets the "Picture Mode".