OSD Menu
77
Sub Menu
Setting Options (Bold: factory default)
Display Name
Sets the name of the main unit. You can input up to 16 alphanumeric characters.
Power Indicator/Button LED Settings
Power Indicator
Brightness
Off
1 to 5 (
3
)
Adjusts the brightness of the power indicator on the main unit. The greater
the number, the higher the brightness.
Display Button LED
On
, Off
Sets the F buttons and the lamp on the face.
Button Name Lighting
Time (sec.)
60
, 30, 10, 5
Sets the time (sec) until the lamp on the face goes out, if no operation is
performed.
Fan Settings
Sets the operation of internal fan.
Fan Control
On,
Off
Fan noise can be eliminated when the main unit is used during shooting or
when silent operation is needed.
Set this in advance to stop the fan either manually or by linking it with the
camera during photography (
71). When this is set to [On], the mode
changes so that the fan can be stopped.
Fan Stop
5
On,
Off
If [Fan Stop] is set to [On] and when [Fan Control] is set to [On], the
fan can be stopped. At room temperature (25 °C), the fan remains off
for approximately one minute (Max of about 6 minutes when using DC
power). The fan operates at a faster speed than usual before and after the
fan is stopped to lower the internal temperature.
Compatible Settings
Sets the connection compatibility with HDMI equipment.
HDMI
Normal
Compatible 1
Compatible 2
[Normal]: All formats are supported.
[Compatible 1]: Set this option when video is not played correctly in
[Normal]. HDR signals of a luminance higher than that of the display
main unit are not supported.
[Compatible 2]: Set this option when video is not played correctly in
[Normal] or [Compatible 1]. [4K50.00P/60.00P] and HDR signals are
not supported.
Protect Settings
Locks the settings so they cannot be changed. When you press the MENU button, [Signal/System
Information] appears, but other operations are grayed out because they are locked.
Password
Set a password to protect settings. Use a four-digit number (0000 to
9999). The initial password is blank.
Protect Target
You can remove Picture Mode and Select Channel from the items to be
protected.
Picture Mode
On
, Off
[On]: Protects the [Picture Mode] settings.
[Off]: Removes the [Picture Mode] settings from protect target.
Select Channel
On
, Off
[On]: Protects the [Select Channel] settings.
[Off]: Removes the [Select Channel] settings from protect target.
Function Settings
On
, Off
[On]: Protects the [Function Settings] settings.
[Off]: Removes the [Function Settings] settings from protect target.
Protect
Select [OK] to protect. When a password has been set, enter the
password and select [OK].
Unlocking Protect Settings
Move the selection frame to [Protect] and press the Jog dial for
approximately 3 seconds. When a password has been set, enter the
password and select [OK].
