Canon ColorPass-Z7400, Руководство по настройке

Страница: 150 / 210

5
5-32 Setting up the ColorPASS from a Windows Computer
Enable SMB Print Services/Enable Windows Printing Service
—Select to enable SMB
(Server Message Block), the file and printer sharing protocol built into Windows.
Enabling SMB lists the ColorPASS on the network so that Windows clients can print
to a particular print connection (Hold, Print, or Direct) on the ColorPASS without
any other networking software. For information on setting up a Windows client for
Windows printing, see the
User Software Installation Guide .
N
OTE
:
Windows (SMB) printing runs over TCP/IP, so you must configure TCP/IP on
the ColorPASS and any computers that use Windows printing.
The remaining options are found only in remote Setup. To change them with local
Setup, use the Local Area Connection Properties Control Panel in Windows XP
Embedded.
Server Name
—Enter the server name that will appear on the network. It can, but does
not have to, be the same name as the server name assigned to the ColorPASS
(see
“Server Name” on page 5-4).
Comment
—Enter information about the printer, up to 15 characters. These comments
are listed in the Properties of the ColorPASS in Network Neighborhood. Lowercase
letters are allowed in this field.
Domain or Workgroup
—Enter the workgroup or domain where the ColorPASS
should appear.
Ethernet WINS Server
—Enter the IP address of the Ethernet WINS name server.
Broadcasts from SMB devices cannot be routed beyond their original network segment
without a WINS name server. Setting up the WINS name server is outside the scope of
this manual. To find out if a name server is available, contact your network
administrator.