Canon C200B, Инструкция по эксплуатации

Страница: 105 / 236

105
Colors Bars/Audio Reference Signal
Colors Bars/Audio Reference Signal
You can have the camera generate color bars and a 1 kHz audio reference signal and output them from the
VIDEO terminal, viewfinder
1
, SDI terminal, HDMI OUT terminal and
×
(headphone) terminal
2
.
1
k
only.
2
Audio reference signal only.
Color Bars
The camera offers 3 types of color bars.
1 Open the [Color Bars] submenu to activate the color bars.
>
[
v &
Camera Setup]
>
[Color Bars]
2 Select [On] and then press the joystick.
• The selected color bars appear on the screen.
• Turning off the camera or changing the operating mode to mode will deactivate the color bars.
3 Open the [Color Bar Type] submenu.
>
[
v &
Camera Setup]
>
[Color Bar Type]
4 Select the type of color bars and then press the joystick.
NOTES NOTES
• If you set an assignable button to [Color Bars] (
A
125), you can press the button to turn the color bars on/off.
• You cannot change the type of color bars while recording or while pre-recording mode is activated.
• While color bars are displayed, peaking, magnification and waveform monitor are not available.
Audio Reference Signal
The camera can output a 1 kHz audio reference signal with the color bars.
1 Open the [1 kHz Tone] submenu.
>
[
¡ $
Audio Setup]
>
[1 kHz Tone]
2 Select the desired level and then press the joystick.
• Available levels are –12 dB, –18 dB and –20 dB.
• Select [Off] to turn off the signal.
• The signal is output at the selected level.
Operating modes: