Canon BS1, Руководство по обслуживанию

Страница: 29 / 29

4
4
4-11
4-11
Installation > Affixing the Labels
Installation > Affixing the Labels
4) When executing punching operation in this condition, the paper stops without switchback
and holes are punched.
5) Measure the dimension [A] between the hole position of the punched paper and the paper
edge to check paper-stop position and adjust it using + (SW384)/- (SW383) button to be in
the position as shown below.
1.75 or more
2.75 mm or less
1.0 or more
2.0 mm or less
2-/4-Hole
2-/3-Hole
0.5 mm or less
(tolerance for front/rear hole position)
0.5 mm or less
(tolerance for front/rear hole position)
[A]
[A]
Paper Stop Position Adjustment value
+(SW384) Increase One press : 0.4 mm
-(SW383) Decrease
6) Perform punching operation again to verify the paper-stop position.
<If the measured value is beyond the adjustment value/rnge>
Repeat adjustment until the measured value is within the adjustment value/range.
<If the measured value is is within the adjustment value/rnge>
Press the ENTER button to terminate the adjustment mode.
7) Restore the DIP switch settings, then attach the Switich Cover and close the Front Cover.
• 1 Screw
8) Turn OFF the power of the Host Machine and the Finisher in order.
F-4-25
T-4-1
Affixing the Labels
1) Open the Front Cover.
2) Affix the Operation Label and the Jam Recovery Label. to the Inner Cover (upper).
Operation
Label
Jam Recovery
Label
3) Affix the Punch Map Labe on the whole Map Labele inside the Front Cover.
FU5-8941
Whole Map Label
Punch Map
Label
4) Close the Front Cover.
F-4-26
F-4-27