Canon 2213C002, Инструкция по эксплуатации

Страница: 132 / 183

Connecting to a Wi-Fi Networ k
132
Manual Setup
If you prefer, you can enter manually the details of the Wi-Fi network you want to connect to. Follow the
instructions on the screen to complete the procedure.
1 Enter the acce ss point' s SS ID (networ k name).
[Edit]
>
Enter the network name using the keyboard screen (
A
128)
>
[OK]
2 S elect the authentication method.
• If you selected [Open], touch [WEP] and continue the procedure, or touch [No encryption] and continue with
the procedure to configure the IP address assignment (
A
129).
3 S elect the WEP index or encryption method, depending on the s elected authentication mode.
• [Shared Key]/[WEP]: Touch one of the buttons to select the WEP index.
• [WPA-PSK]/[WPA2-PSK]: Touch [TKIP] or [AES].
4 Enter the encryption k ey (pa ss word).
[Edit]
>
Enter the password using the keyboard screen (
A
128)
>
[OK]
5 Continue with the procedure to configure the IP addre ss a ss ignment (
A
129).
NOTES NOTES
Valid passwords vary depending on the encryption method.
64-bit WEP encryption: 5 ASCII characters or 10 hexadecimal characters.
128-bit WEP encryption: 13 ASCII characters or 26 hexadecimal characters.
AES / TKIP encryption: 8 to 63 ASCII characters or 64 hexadecimal characters.
* Note: ASCII characters include the numbers 0 to 9, the letters a to z and A to Z and some punctuation marks and special
symbols. Hexadecimal characters comprise the numbers 0 to 9 and the letters a to f and A to F.