Canoga Perkins EDGEACEESS 9145E, Руководство пользователя, Страница: 41 / 54

Operation 9145E Ethernet Network Interface Device User Manual
Interface Management
41
4.1.2 SFP/UTP Port Status LEDS
The Link/Activity (LNK/ACT) LEDs are located above the SFP and UTP Ports of the each port
section (see Figure 4-1). See Table 4-2 to determine the current condition of the User Ports.
Table 4-2. User, Network, and Multipurpose Port LED Indications
4.2 Interface Management
The 9145E is managed locally through the console port. It is managed remotely either through
the Ethernet Management port, or inband through the network or User port. The console port is
connected to a VT-100 terminal, through an emulation program, through the RS-232 serial port
using a DE-9 cable. The Ethernet Management Port is an out-of-band 10/100 Mbps management
port supporting Telnet, SSH, and SNMP V1/V2C/V3.
4.2.1 Setting Up the VT-100 Terminal
When using the console port, you can use the HyperTerminal Emulation program that is included
with Microsoft Windows operating systems. The Telnet session is only available after the
management TCP/IP configuration is completed.
LED Name State Condition
SPD
Off
10BaseT
Auto
Connector Not Selected
Green 1000BaseT
Amber
100BaseTX
System Test
Red Remote Fault (SFP Only)
Blinking Red Invalid/Unsupported SFP installed (SFP Only)
Slow Blinking Green* Connector Selected with No Link
LNK/ACT
Off
No link
No transmit or receive activity
Green Link on with full duplex
Blinking Green Transmission or receiving activity with full duplex
Amber
System test
Link up with half duplex
Blinking Amber Transmission or receiving activity with half duplex
Red
Port Disabled
LLF
Blinking Red No Link, but transmitting OAM packets in unidirectional mode
* Slow Blinking Green means the LED toggles between OFF and GREEN approxi-
mately once per second.