Routine Cleaning
2-59
2
Ro
utine Main
te
nan
ce
Wire Cleaning
If streaks appear on printed output, or random parts of the printed image are
missing, clean the corona assembly wires inside the main unit.
NOTE
•
It takes approximately 35 seconds to clean the wires.
•
Wire cleaning cannot be performed during printing.
•
The machine may clean the wires automatically if it detects that the wires are dirty.
1
Press
(Additional Functions)
➞
[Adjustment/Cleaning]
➞
[Wire Cleaning].
2
Press [Start].
When cleaning is complete, try printing again.
Drum Cleaning
If you use the machine immediately after installation, or if the machine is not used
for a long period of time, such as during a holiday, there may be rare cases in which
the images printed become light or distorted. If the images printed are light or
distorted, clean the drum as necessary.
NOTE
•
It takes approximately 5 minutes to clean the drum.
•
Drum cleaning cannot be performed during printing.
1
Press
(Additional Functions)
➞
[Adjustment/Cleaning]
➞
[Drum Cleaning].
2
Press [Start].
NOTE
If you do not want to perform cleaning, press [Cancel].
Содержание imageRUNNER 5075
