Cannon 110cm Free Standing Gas Cooker C110DPX, Инструкция по установке и эксплуатации

Страница: 16 / 32

16
Electronic Clock & Automatic Cooking Feature
When you first switch on the appliance you will be prompted to set the “Time of Day” on
the display. You must ensure you have done this before attempting to use the automatic
cooking feature.
AUTOMATIC
COOKING The 1st oven can be controlled automatically.
HINTS ON
AUTOMATIC
COOKING - Select food which will require the same cooking time and temperature.
- To ensure food does not cool down and require reheating, set the end time so the food is ready when
you require it.
- Always ensure that meat and poultry is defrosted before placing in the oven.
- Whenever possible, take food out of the refrigerator and keep it as cool as possible.
- If cooking food that requires frying before placing in the oven for automatic cooking, keep the delay
time to a minimum.
- Never place hot or warm food in the oven for delayed start cooking as it could cause the oven to be
warm and produce harmful bacteria in the food.
- We advise that dishes containing left-over cooked poultry and meat, eg. shepherds pie, should not be
cooked automatically if there is to be a delay period.
- Ensure that delay start times are kept to a minimum to prevent bacterial growth in food.
- Wine or beer may ferment and cream may curdle during the delay period, so it is best to add these
ingredients just before serving.
- Foods which discolour should be protected by coating in fat or tossing in water to which lemon juice
has been added, prior to placing food in the oven.
- Dishes containing liquid should not be filled too full to prevent boiling over.
- Food should be well sealed (but not airtight) in a container to prevent the loss of liquid during cooking.
Aluminium foil gives a good seal.
- Always ensure that food is piping hot and cooked thoroughly before serving.
- Only reheat food once.
SETTING THE
TIME OF DAY:
STEP 1. Check the electricity supply to the cooker is turned on.
STEP 2. When switched on the display will show both 00:00 and the “set time” symbol flashing. Wait
until these stop flashing.
STEP 3. Press the Time/Mode button once, so that the “Set Time” symbol and the display are flashing.
Turn the +/- control knob until the correct hour is set.
STEP 4. Press the Time/Mode button once, so that the “Set Time” symbol and the display are flashing.
Turn the +/- control knob until the correct minutes are set. Press the Time/Mode button again.
TIME OF DAY IS NOW SET.
To alter the time of day after the first setting, simply press the Time/Mode button.
The “Set Time” symbol and the display will flash. Repeat STEPS 3 and 4.