5- You can turn the function selector back to " 0 " but if the temperaure
is still high, the "0--n " indication appears to inform that the door is
locked.
1- Rotate the function selector into position pyrolisys. The display will
show either "ECO" or "SUP“
4 - Once the pyroclean cycle is finished, the pyrolysis will switch off
automatically. On the display appears the indication "END" until the
door is locked then "0--n".
2- The pre-set time is 90 minutes but it can be varied from 90 min. (Eco
mode) to 120 min. (Sup mode) using the programmer (" +" or "-" key).
If the oven is very dirty, the time should be increased to 120 min., while
if the oven is only a slightly dirty, reduce the cleaning cycle to 90 min.
Use of the pyrolytic cycle in Touch Control ovens:
300 ml
The Aquactiva procedure uses steam to help remove remaining
fat and food particles from the oven.
1. Pour 300 ml of water into the Aquactiva container at the bottom
of the oven.
2. Set the oven function to Static ( )or Bottom ( )heater
3. Set the temperature to the Aquactiva icon
Make sure that the appliance is cool before you touch it.
5. After 30 minutes switch off the program and allow the oven to
cool down.
Warning:
Use distilled or drinkable water.
4. Allow the program to operate for 30 minutes.
Care must be taken with all hot surfaces as there is a risk of burns.
6. When the appliance is cool, clean the inner surfaces of the oven
with a cloth.
4.3 Aquactiva Function
REMOVAL OF THE OVEN DOOR
2. Open the clamps of the hinge housing on the right and left side
of the front window by pushing them downwards.
3. Replace the window by carrying out the procedure in reverse.
1. Open the front window.
4.4 Maintenance
A
REMOVAL AND CLEANING OF THE SIDE RACKS
1. Unscrew the bolt in an anti-clockwise direction.
2. Remove the side racks by pulling them towards you.
3. Clean the side racks in a dishwasher or with a wet sponge and
then dry them immediately.
4. Having cleaned the side racks, put them back in and reinsert the
bolts, ensuring that they are fully tightened.
1.
2
.
3.
4
.
LOW-E
1
2
3
5.
6
.
7.
EN 09
5.6. Remove the glass, carefully extracting it from the oven door (NB:
in pyrolytic ovens, also remove the second and third glass (if
present)).
2.3.4. Lock the hinges, remove the screws and remove the upper
metal cover by pulling it upwards.
On all glass, the indication "Pyro" must be legible and positioned on
the left side of the door, close to the left-hand lateral hinge. In this way,
the printed label of the first glass will be inside the door.
REMOVAL AND CLEANING OF THE GLASS DOOR
1. Open the oven door.
7. At the end of cleaning or substitution, reassemble the parts in
reverse order.
