TOOLS AND MATERIALS REQUIRED:
SAFETY PRECAUTIONS:
INSTALLATION:
Blade
Screwdriver
Phillips
Screwdriver
Wire Cutters
Pliers
1.
Run black, white and green wires from fixture through arm.
2.
Screw the arm onto the shade. Put the back plate and back plate
gasket in place. Seal other end of arm into back plate with gasket in place.
3.
Connect the ground wires (bare copper or green) from your fixture to
the ground wire (bare copper or green) or ground screw in the electrical
outlet box. Connect black wire from fixture to black wire in outlet box and
connect the white wire from fixture to white wire in outlet box.
4.
Put back plate gasket in place and attach backplate to junction box
using screws provided.
5.
Align fixture and secure by tightening set screws on backplate.
6.
After Installation, seal around the top and side perimeter between the
fixture and the wall surface with weather resistant caulking. The bottom
should be left un-caulked to prevent moisture build-up.
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Wiring supplies
as required by
local electrical
code
Tel: (613) 342-5424, Fax: (800) 263-4598
Shade
White Wire
Back Plate
Ground
Wire
Black Wire
Arm
Electrical
Box
WARNING: SUITABLE FOR WET LOCATIONS WHEN
THREADS ARE SEALED WITH TEFLON
TAPE OR PIPE SEAL.
!
Weather Resistant Caulking
(not included)
Weather Resistant Caulking
(not included)
Back Plate Gasket
Set Screws
Screws
Back Plate
Back Plate Gasket
LED OUTDOOR
LIGHTING
LBL167A14WACBK
01/19
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
4. NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
