FLUIDS
704904124
WARNING
The Spyder roadster is a different type of vehicle -
The Spyder roadster is a different type of vehicle -
it requires special skills and knowledge.
it requires special skills and knowledge.
Learn how the Spyder roadster is different.
Learn how the Spyder roadster is different.
Read
ead
the operator's guide (in the front storage compartment)
and watch the safety video.
Comple
omplete
a training course (if available),
practi
tice
, become
proficient with the controls, and get a proper license.
Refer
er
to the Safety Card before riding.
Always wear a helmet and riding gea
ear a helmet and riding gear.
With this type of vehicle, riders are exposed to more road risks
than in a car. Even skilled operators can be struck by other
vehicles or lose control. This vehicle will not protect you in a
crash.
Handling
andling limits and
limits and road
oad conditions
onditions
The Vehicle Stability System (VSS) cannot stop you from
losing control, flipping over, or falling off if you exceed this
vehicle’s limits. Know the limits for different road conditions.
Do not ride on ice, snow, or off road. Avoid puddles and running
water. This type of vehicle can hydroplane on water and slip on
gravel, dirt and sand covered roads. If you must go through
these road conditions, slow down.
This hangtag may only be removed by the customer.
704904124
Licence Plate Installation
NOTE:
When a license plate needs to be installed
or replaced, ensure to install two new damping
pads (P/N 293 740 028) on plate to be installed.
1. Remove existing plate on vehicle (if applicable).
2. Peal off backing of new damping pads.
rmo2008-002-509_a
1. Damping pad backing
3. Position new damping pads over existing pads
on vehicle plate support.
rmo2008-002-510_a
TYPICAL
1. Damping pads
4. Secure upper portion of license plate on vehicle
plate support using existing hardware.
5. Squeeze license plate and support together at
each lower corner.
Accessories Installation
1. Install accessories (if any) as per their installa-
tion instructions (included in each kit).
2. Install any other equipment required by law (if
any).
Vehicle Decals
1. Install decals on vehicle according to customer
country language and local legislation.
2. Ensure that the new decals are installed at the
same location and over the factory installed de-
cals.
FLUIDS
General Guidelines
All fluids (except fuel) have already been filled
at factory, it is only necessary to validate them.
However, if refill is needed, refer to the appropri-
ate
ROADSTER SHOP MANUAL
for the proper
procedure.
Fuel
1. Add fuel in the fuel reservoir.
26 / 41
2014-3
PREDELIVERY
