PARTS TO BE INSTALLED
3. Firmly push the mirror inwards until it engages
with the bottom two studs.
4. Ensure mirror is properly secured.
Front Fenders
NOTE:
Fender installation similar on both sides.
1. Cut locking ties that hold wire harnesses to
fender supports.
rbl2011-002-010_a
TYPICAL
1. Locking tie
2. Ensure proper position of fender wiring har-
ness.
NOTE:
LH illustrated, RH similar.
rbl2014-004-048_a
1. Wiring harness clamps
2. Wiring harness bracket
NOTE:
Do not remove protection from suspension
arms.
rbl2013-004-002_a
TYPICAL
3. Position front fender on vehicle.
rbl2011-002-011
TYPICAL
4. Install 4 M8x 20 hexagonal flange screws
loosely to hold the fender in its position.
NOTE:
Be sure to install the fender light harness
and ABS harness brackets as illustrated. Do not
torque screws at this time.
NOTE:
Left side fender installation illustrated,
right side similar.
rbl2014-004-049_a
1. Fender light harness bracket, top screw, forward fender support
2. ABS harness bracket, lower screw, rear fender support
3. ABS sensor
PREDELIVERY
2014-1
27 / 52
