Camsat iCAM-Mobile HD II, Руководство пользователя

Страница: 9 / 44

3.3. Connecting the power supply
A) With 230V
When using the 230V network, the iCAM-Mobile power plug should
be plugged into a socket adapted to the conditions of use, i.e. an
external hermetic socket or a socket with a plug closed in another
hermetic housing / box.
After turning the key in the ignition switch to the "I" position, two lights on the external
panel should light up (STATUS NVR, MAIN POWER).
Wait about 1 minute, then check the configuration of the recorder, wireless connection
and IP camera, and correct the settings if necessary. Detailed information can be found
later in this manual.
To turn off the device, turn the key in the ignition switch to the "0" position and discon-
nect the 230V power supply.
B) With external battery or source of 12-24V
The device can be powered from an alternative DC power source, e.g.
•
external 12-24V battery,
•
electric installation of car - 12V or 24V,
•
other 12-24V installation.
The power source must have a minimum capacity of 40W (e.g. 3.5A/12V or 2.2A/24V).
WARNING
When iCAM-Mobile works in this configuration, the internal battery will not be
charged.
In the indicated place, connect the 12-24V DC power sup-
ply according to the marked polarity (+ - car power supply
12-24V DC),
After turning the key in the ignition switch to the "I" posi-
tion, four lights on the internal panel should light up (STA-
TUS NVR, HDD and NVR power supply, MAIN power supply,
IP CAMERA power supply).
Wait about 1 minute, then check the configuration of the recor-
der, wireless connection and IP camera, and correct the settings
if necessary. Detailed information can be found later in this ma-
nual.
To turn off the device, turn the ignition key to the "0" position
and disconnect the "alternative" power supply.
Page 9