Camsat iCAM-Mobile HD II, Руководство пользователя

Страница: 20 / 44

5. Remote access to the iCAM-Mobile HD system
5.1. Remote access to the system
To perform the configuration, connect the radio module to the computer wirelessly using
a 5 GHz WiFi network (802.11a or 802.11n standard). The default network name (SSID)
is "CAMSAT". The configuration of the iCAM-Receiver is described in section 5.5. Confi-
guration of iCAM-Receiver.
Devices working only in the 2.4 GHz band (in 802.11b and 802.11g standards)
are incompatible with iCAM-MobileHD! An iCAM-Receiver (not included) can be
used as the receiving device.
5.2. Access to the iCAM-Mobile HD system using the device
with Android or iOS
Connect to a Wi-Fi network using the previously configured network name and password
(default SSID: CAMSAT).
If the device did not obtain the IP address automatically, you must manually
enter the static unique IP address, default gateway and subnet mask in
advanced options when connecting. The DHCP server must be enabled for
automatic device configuration:CAMERA CONNECTION SETTINGS > Network
Settings.
5.3. Access to the system through the wire
The device can be connected to the network using the RJ45 socket in the LTE module ho-
using.
5.4. Emergency access to the system through the wire
If it is not possible to establish a wireless connection, connect the device with a network
cable in the place where the camera is connected to configure the system.
WARNING
The RJ-45 socket for IP camera has + 48V voltage in PoE+ standard. The power
supply is sent through free 4/5 (48V blue pair) and 7/8 (0V brown pair) wires.
To connect the system to an incompatible switch or network card, leave these
wires unconnected in the RJ45 plug.
Page 20