EU
EU
MADE IN
POLAND
MADE IN
POLAND
CAM8H-AHD User’s manual
1. Installation
Secure the device to a mast by using UV zip tie fasteners, and direct the antenna directly
to the reception point. Note: The antenna of the transmitter must be in a line of sight with
the antenna of the receiving unit (the antennas must be directed onto each other as
shown in the drawing below).
The units should be powered on in turns, i.e. one after the other. It is not recommended
to power on all transmitters at the same time.
Begin by activating the first transmission link, and only once it is fully operational proce
-
ed to activate another link in the same way. This will facilitate activating and selecting
spur operating channels.
Connect the video cables to the BNC or UTP port and the audio cables (only for
PAL/NTSC) as specified in the description. Set the required channel as per the table.
Antenna polarisation (vertical installation) and channel number must be the same for
both interconnected transmitter-receiver devices.
Set the required channel as shown in the table and select the same channel for the trans-
mitter and the receiver.
IV. Quick Start
Transmission of video and audio for the standard CVBS , PAL 960H
Broadcast cameras AHD-M and AHD-L
6