Campomatic GH3BL, Инструкция по эксплуатации

Страница: 6 / 12

Ÿ
Periodically clean the exterior and rear cylinder, storage area of your heater
to remove dust and lint built-up, which may affect operation of the heater.
Ÿ
Light vacuuming with a soft brush will remove any dust built-up on the
surfaces of the ceramic elements. Do not scrape of knock these elements as
they may become very fragile with use.
Ÿ
Do not use abrasive products to clean the heater.
Ÿ
Watch the pilot flame while it is in operation. it should burn steadily. If it
flickers or is yellow tipped, the heater should be checked for correct
operation.
Ÿ
If any parts need replacement, they must be replaced only with genuine
original parts supplied by the manufacturer. The use of incorrect or substitute
parts may be dangerous and will void any warranty.
Operation the heater according to following procedures when electric power is use.
The electric heating system is designed with technology of infrared radiation.
Even if it is used in an unsealed and large size room, heating efficiency will be
perfect.
1) Operation
Ø
Make sure plug is normally earthed. Put plug in the socket
Ø
Press switch to start the top quartz tube.
Ø
Press switch to start the other two quartz tubes.
Ø
Press switch and to start all quartz tubes. Heat load reaches to peak.
Ø
Turn all switch off after use. Remove the plug from the socket.
As shown in below Figure
Note:
To prevent too high temperature near the air-outlet grilles, it is recommended
that in the use of gas and the electric heating elements in the heater should not
be used at the same time.
2) Specification (TBK-GE01)
6