www.camplux.com
30
Visit Us: Camplux.com
8350 Patriot Blvd STE B, North Charleston, SC 29420
1(844) 538-7475
1. Verify the power switch on the water heater is in the
“OFF”position.
2. Turn on the gas supply or alternative pressure supply.
3. Check the appliance and all gas connections for gas
leaks with leak detection liquid (not provided) or an
equivalent gas leak detection method. Bubbles indicate
a gas leak that must be repaired.
4. Repair gas leaks as needed.
5. Repeat gas leak check after any adjustments to loose
connections.
NOTE:
After leak checking, make sure the gas supply pressure corresponds to
the operating pressure of the appliance 10.5~14 in.WC (2620Pa~3490Pa).
Checking for water leak
1. Verify the power switch on the water heater is in the “OFF”position.
2. Turn on the water supply to the appliance.
3. Open water faucets to fill the system with water. Close the faucets when the
water is flowing smoothly and all air is removed from the lines.
4. Check all connections for water leaks by eye and touch.
5. Repair water leaks as needed.
6. Repeat water leak check after any adjustments or loose connections.
WARNING
Risk of death and personal injury through fire and/or explosion!
●
DO NOT use matches, candles or other sources of ignition when checking for
gas leaks.
●
After the gas supply is connected, check for gas leaks at all gas connections.
Use a gas leak detection liquid or equivalent. Ensure test pressure are below
40 in.wc (100kPa)
●
Make certain to re-test all fittings after making adjustments to loose
connections.
●
Failure to follow instruction may lead to serious injury,property damage or death.
Check After Installation
Checking for gas leak
Bubbles indicate
gas leak
