www.camplux.com
12
Visit Us: Camplux.com
8350 Patriot Blvd STE B, North Charleston, SC 29420
1(844) 538-7475
●
Always disconnect the 12V appliance (to protect the control from surges that
may occur) when performing Dielectric (hi-pot) testing, welding, electrical, and
work on the coach.
●
Only use with a proven 12V power source such as battery or approved
converter.
●
DO NOT vent the water heater using a venting system serving another
appliance.
●
DO NOT install directly into a shower, or near direct heat.
●
DO NOT use a battery charger to supply power to the appliance, even when
testing.
Installation location requirements
Select a suitable location for your appliance fixing. The appliance is designed to
be installed on a floor or a fixed platform with access to water. Electrical
connections are established at the back. Gas access, water inlet, and hot water
outlet connections are from the rear also.
The appliance is designed exclusively for installation on an
OUTSIDE WALL
of
an RV.
Installation of the alter heater on the back of a trailer is not advised because of
high pollution caused by dirty and wet roads.
●
DO NOT vent the water heater using a venting system serving another
appliance.
● DO NOT install the appliance in any location where the vent may be covered
or obstructed when any door on the RV is opened or due to the design of the
RV or due to special features of the RV such as slide-out, pop-up, etc.
● DO NOT install on a swing door.
● DO NOT install the appliance in such a way that the cover plate is less than
– 1 foot from each side and top of any window, slide-out, or opening into the RV.
– 6 feet from any mechanical air supply inlet
– 3 feet from any gas tank connection or ventilation.
● Maintain a minimum clearance from combustible materials on sides (4 in), top
(4 in), floor (0 in) and rear (0 in).
● Provide room for access to rear of appliance for servicing.
WARNING
Risk of poisonous exhaust gases due to improper installation!
●
Make sure that the appliance is installed as described below.
