Campbell RF407 Series, Инструкция по эксплуатации

Страница: 21 / 51

RF407-Series Spread Spectrum Radio
10
7.7.3 Antenna Cables
Some antennas require an additional antenna cable to connect to the radio
directly or to an interconnected surge protector.
COAXRPSMA-L is a LMR195 coaxial cable terminated with a Type N plug
on one end and a RPSMA plug on the other. The COAXRPSMA-L can be used
to connect antennas with a Type N jack connector directly to the RF407-series
radios. Such antennas include the 14201, 14205, and 14221.
COAXNTN-L is a RG8/U coax cable terminated with a Type N plug on both
ends. The COAXNTN-L is typically used to connect antennas with a Type N
jack connector to an inline surge protector, or to a bulk head Type N jack.
8. Configuring the RF407 Series
8.1 DevConfig
DevConfig is the primary tool for configuring the radio. DevConfig version
2.11 or later is required. DevConfig can be downloaded free of charge from
www.campbellsci.com/downloads .
INSTALL the DEVICE DRIVER BEFORE plugging the radio
into your PC for the first time. You will need the device driver
properly installed before you can connect to the radio via USB. To
install the device driver using DevConfig , select Radio | RF407
Series under Device Type . Click the Install the USB device
driver link and follow the prompts.
1. Open DevConfig .
2. Under Device Type , select Radio | RF407 Series .
3. Carefully review the Connect Instructions text provided on the right.
4. With the USB device driver installation complete, connect the supplied
USB cable between the USB port on your computer and the USB port on
the radio.
5. Click the
Browse
button next to
Communication Port
.
6. Select the port labeled RF407-Series .
7. Click OK .
8. Click Connect .
9. Configure the radio as needed for your application. See Section 11 ,
Operation
(p. 16)
.
10. Click Apply to save your changes.
NOTE