Campbell PVS5120 Series, Инструкция по эксплуатации

Страница: 47 / 102

PVS5120-Series Portable Samplers
35
TABLE 8-3. Numeric Response Codes of the VSC100
Numeric
Response Code Definition
0 No Error: Successful Sample
1 All samples complete
2 Low start battery (Voltage <11.0 Vdc)
3
Low run battery
(Voltage <10.5 Vdc occurs after pumping has started)
4 Sampler vacuum timed out; no sample detected
5
Sample overflow detected (only if an overflow sensor is
installed; only available for stationary samplers)
6
No sample liquid detected (only if water detection probe
is installed and configured)
7 Arm calibration error
8
Liquid Sensing/Conductivity Rod and
Volume Control Tube are shorted
For all CRBasic dataloggers, except the CR200(X) series, the
SDI12Recorder()
instruction has the following form:
SDI12Recorder( Destination, SDIPort, SDIAddress, “SDICommand”,
Multiplier, Offset )
Where,
• Destination – For the sampler, the destination location should be a
four value array.
•
SDIPort – Datalogger control port to which the sampler is connected.
• SDIAddress – This address must match the sampler’s address. The
sampler’s default address of 0 should be used unless more than one
SDI-12 device is connected to the same port. The sampler’s default
address is changed using DevConfig .
• SDICommand – The only commands recognized by the sampler are
“ M! ” and “ C! ” . The “ C! ” command should only be used if you want
to run SDI-12 sensors concurrently. The command needs to be
enclosed in quotes.
The PVS5120 does not support extended SDI-12 commands.
Use the default values of 1.0 and 0.0 for the Multiplier and Offset , respectively.
NOTE